* Removed rated power (not used anymore)
* Removed rated engine speed form engine file. Now calculated form vfld file.

* Target deceleration (.vacc file) doesn't work right if distance-steps in driving cycle are too large. Now limited to 1[m].
* Bugfix: When moving job files up or down in job list the "checked jobs" counter was incorrectly reduced.
* Bugfix: Vehicle Editor: "New file" had invalid axle configuration (caused crash when trying to edit).

* Bugfix: Eco Roll didn't go into motoring operation when Overspeed-Limit was reached (could cause higher FC than Overspeed Mode)
* Minor update in demo data (12t motoring curve)
* Cleared up Demo Data
* Small fix in User Manual

- Speed reduction in smaller steps to get closer to full load curve (before speed was sometimes reduced too much and caused problem with gear shifting)
- Updates in demo data

- Torque converter update: rpms over rated speed are not allowed.
- Fixed Wheels inertia in Demo Data

- Exact road gradient calculation (see changelog)

- Bugfix: Gears using torque converter and transmission loss maps may cause invalid "out of engine operation range" errors
- Null values for FzISO will abort calculation

* Use '*' char for lists.

* Set ver for release from 1.4 --> 1.4.RC4,
* Updated Update Notes,
* DID NOT moved VECTO_LIC project's dir, in 'default' branch not belonging (yet:-) to the solution.

- Added twin tyres option for load-dependent RRC
- bug fixes

- Update Notes updated (still open: File Signing)
- Load-dependent RRC finished

- Files can be converted in JSON format. Backup will be created.
- Option in Settings whether to use JSON format or not
- Finished load-dependent RRC

- JSON signature file

-small changes in User Manual
-update in .vecto JSON input: Parameters not needed in Engine Only are now optional

- fixed stoptime in cycles.... again
- stoptime errors will abort after finding all invalid stoptimes (not after the first one)
- TEST: New JSON format for VECTO files (.vecto). Old files compatible.

- restructured Demo / Default Data

- "zero" stop-times are no longer allowing in distance-based cycles
- bugfix: Stand-still at cycle end (distance-based) was ignored
- bugfix: Crashes when distance correction at end of cycle
- added default cycles to repo (TODO: default input files)
- added Update Notes to repo

- When speed is under 5km/h and engine in motoring operating then gearbox shifts to Neutral
- "Minimum (actual) speed" instead of "Min. Target Speed" (Eco-Roll, Overspeed, Look Ahead Coasting)

- <DRAG> keyword in Engine Only mode enabled
- variable gear number / TC possible in multiple gears
- transmission loss approximation for PreRun and Gear Shift Model

- Torque Converter updates ....still in development

- Same job file list for BATCH and STANDARD
- FC extrapolation will not abort calculation. Invalid FC values are marked in output as "ERROR".
- Bugfix: FC interpolation failed when load points matched map points exactly.
- Bugfix: Invalid "FC= -10000!" errors when outside of FC-Map
- Updates in torque converter IN DEVELOPMENT
- No abortion if transmission output and input torque have different signs (In>0, Out<0)
- Updated modal results header
- New parameters in modal results (see changelog)
- Bugfix: Error if Look-Ahead Coasting was disabled.
- Eco-Roll revised (see changelog)
- Removed "IgnoreFCextrapol" form DEV-Options