How to run the "Engine Only Mode" in VECTO v3.3.13.2924

As described in the user manual of VECTO v3.3.13.2924 I have prepared the route data for "ENGINE ONLY MODE" but where is the interface it?? Please help me out on that.

changed title from How to run the "Engine Only Mode" in VECTO-3.3.13.2924 to How to run the "Engine Only Mode" in VECTO v3.3.13.2924

changed the description

Hi @n00cypdc, under the folder 2023_01_03-VECTO-3.3.13.2924\Generic Vehicles\Engineering Mode\EngineOnly you will find an example that can serve as base for your test case. Best Regards, Vangelis

added statusin review label

Thanks for your help, I have made the input files as per the Engine Only mode please guide me how I can run the Engine Only mode in Engineering Mode. I have attached a snap from the user manual, this interface I am not being able to find, please help me out with this.

@n00cypdc, If you have prepared all your files, just start the VECTO software and load the ".vecto" job file for engine only mode. Then just click the start button and the simulation will start.

YES, we have ran it that way, but where is the interface for the As the Engine Only Mode .vecto job file is modified from the .vecto file in the Engineering Mode how the results are affected, is there any effect of the gearbox or vehicle file on it or not. If yes, then please elaborate.

assigned to @bitsaev

mentioned in issue #247 (closed)