TorqueConverter: Initialize: When no operating point was found only write a Log.Warn if outTorque and speed are not zero. Otherwise write a Log.Info.

bugfix: handle the case where REESS voltage is above high voltage level of EM (results in NaN during interpolation)

VelocitySpeedGearshiftPreprocessor: Removed try-catch again because error was solved in TransmissionInputRetarder.

Retarder: Corrected error for TransmissionInputRetarder when Gearbox is diseanged but clutch is closed.

VectoRun: Throw exception when Cycle could not be finished even when the reason was "Battery Empty" (but using a useful error message).

(cherry picked from commit 3616be920ab45fab3067cda39a69f2c0cf120643)

EngineeringModeVectoRunDataFactory: Added check for Serial Hybrids that ElectricMachines must be defined.

JSONFileWriter: Added conditional writing of fields for SerialHybrids: IdlingSpeed, AngleDrive, PTO, TorqueLimits, Tanksystem

calculating energy demand in certain gear mixed up torque and motor speed from drivetrain and EM. estimate torque at EM by applying ADC ratio

 bake testcase P4 Hybrid Urban green: disengage ICE during roll action if AllowEmergencyShift is set (i.e. ICE speed is too low), retry roll action in driver model in this case

check if there is a successor/predecessor before checking shift polygon

Minor changes in DebugData (Local Variable stores LocalData, but all will also be stored in Global Data)

HybridStrategy: replaced EngineSpeedTooLow Variable by direct function evaluation with current response

correcting powertrain builder: building simple parallel powertrain, connect idle controller after powertrain is connected togehter

update expected values in adas test after changes in clutch (not resetting idel controller on dry-runs)